Ricoh D127 Field Service Manual page 408

5. Appendix: Fax Service Program
No
TTI printing position
0: Superimposed on the page
0 data
1: Printed before the data leading
edge
1-2 Not used
TTI used for broadcasting
0: The TTIs selected for each
3 Quick/Speed dial are used
1: The same TTI is used for all
destinations
4-7 Not used
System Switch 12 [SP No. 1-101-019]
No
TTI printing position in the main
0-7
scan direction
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 [SP No. 1-101-022]
No
0 Not used
200
FUNCTION
FUNCTION
FUNCTION
COMMENTS
Change this bit to 1 if the TTI overprints information that
the customer considers to be important (G3
transmissions).
Japan Only
1: The TTI (TTI_1 or TTI_2) which is selected for all
destinations during broadcasting.
*TTI= Transmit Terminal Identification
Do not change the factory settings.
COMMENTS
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the TTI
from the left edge of the paper. If the TTI is moved too far
to the right, it may overwrite the file number which is on
the top right of the page. On an A4 page, if the TTI is
moved over by more than 50 mm, it may overwrite the
page number.
COMMENTS
Do not change the settings.