Sp4-Xxx (Scanner) - Ricoh D127 Field Service Manual

3. Appendix: SP Mode Tables
JobEnd / Interrupt
2995 3
Sets the condition at which ID sensor control takes place.
2996* Transfer Roller Cleaning
Cleans or does not clean the transfer roller before each job. Select "1" if the backside of
the paper becomes unclean when output. Note that the copier takes a longer time to
2996 1
output the first copy when you select "1". If you select "0", the transfer roller is never
cleaned.
Interval
2996 2
When the "SP2-996-003" counter is over this SP's value, Transfer roller cleaning is
activated on the Job-End timing. If this SP's value is 0, cleaning doesn't act.
Counter
2996 3
The counter Applying to "SP2996-002" (Interval).
2998* PCU Reverse Rotation Time
2998 1 Wait Time
2998 2 Reverse Time
Brake Time
2998 3
DO NOT use this SP in usual operations.

SP4-XXX (Scanner)

4008* SubScan Mag Adjustment
Adjusts the sub-scan magnification (
4008 1
"Replacement and Adjustment").
4010* L – Edge Regist Adjustment
Adjusts the leading edge registration (
4010 1
"Replacement and Adjustment").
4011* S-to-S Regist Adjustment
40
-
[0 = No / 1 = Yes]
[0 to 100 / 50 / 1 /step]
[0 to 255 / 0 / 1 /step]
[0 to 999 / 300 / 1 /step= 30ms]
[0 to 99 / 60 / 1 /step= 6ms]
[0 to 99 / 0 / 1 /step= 3ms]
[-1.0 to +1.0 / 0.0 / 0.1 %/step]
"Adjusting Copy Image Area" in the section
[–1.0 to +1.0 / 0.0 / 0.1 mm/step]
"Adjusting Copy Image Area" in the section
[–2.0 to +2.0 / 0.0 / 0.1 mm/step]