Test Pattern Printing (Sp2-12) - Ricoh G035 Service Manual

4.2.3 TEST PATTERN PRINTING (SP2-12)

NOTE: Do not operate the machine until the test pattern is printed out completely.
Otherwise, an SC may occur.
1. Access the SP mode 2-12, then select a test pattern number by
2. Press the "Enter #" key to store the test pattern.
3. Access the SP mode 2-22-2 (SMC Printing - SP Mode Data).
4. Press "Enter #" to print selected test pattern.
5. After finished test pattern printing, do either of the following steps to clear
stored test pattern.
–access the SP mode 2-12 and set test pattern to "0" (None), then exit the SP
mode
–turning off and on machine
6. Exit the SP mode.
Test Pattern Table (SP2-12: Test Pattern Printing - Printing)
No.
0 None
1 Vertical Line (1-dot)
2 Horizontal Line (1-dot)
3 Vertical Line (2 dot)
4 Horizontal Line (2-dot)
5 Grid Pattern (Single-dot)
6 Grid Pattern (Double-dot)
7 Alternating Dot Pattern
8 Full Dot Pattern
9 Black Band
10 Trimming Area
G035
Test Pattern No.
11 Argyle Pattern
12 16 Grayscales (Horizontal)
13 16 Grayscales (Vertical)
14 16 Grayscales (Vert./Hor.)
15 16 Grayscales (Vert./Hor Overlay)
16 Not used
17 Horizontal Line (1-dot)
18 Grid Pattern (Single-dot)
19 Grid Pattern (Double-dot)
20 Alternating Dot Pattern
4-14
SERVICE PROGRAM MODE
or
Teat Pattern
key.
SM