Toshiba e-STUDIO 2555C Service Manual page 642

Classification
Paper jam in finisher section
Phenomenon of paper jamming
All
Parts to be replaced
Entrance sensor
Transport sensor
Processing tray sensor
Buffer roller drive motor
Buffer tray guide motor
Finisher contoller PC board
MJ-1108
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Error content
Paper transport stop jam (transport sensor)
Paper transport stop jam (between entrance & transport sensor)
Paper transport stop jam (after paper stack exit)
Paper transport stop jam (stop command request)
Paper transport stop jam (paper not inserted)
Paper transport stop jam (paper holder plate operation delay)
Paper transport stop jam (stack transport delay)
Check item Measures
Finisher Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if
there is.
Entrance • Sensor check
sensor (S1) • Connector check
• Harness check
Transport • Sensor check
sensor (S2) • Connector check
• Harness check
Processing • Sensor check
tray sensor • Connector check
(S12) • Harness check
Paper holding Is there any mechanical problem when the paper
cam holding cam is rotated?
Buffer roller • Motor check
drive motor • Connector check
(M6) • Harness check
Buffer tray Open and close the buffer tray guide.
guide If there is any mechanical problem, fix its
mechanism.
Buffer tray • Motor check
guide motor • Connector check
(M3) • Harness check
Finisher • Board check
control PC • Connector check (CN7, CN11, CN18, CN22)
board (FIN) • Harness check
Remark
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 86