Check item
Entrance motor (M1)
Interface PC board (I/F)
Saddle stitcher controller board
Replace parts
Junction box paper detection sensor
(S26)
Feeding sensor (S22)
Transport path-2 (S27)
Transport path-3 (S28)
Ejecting roller (S29)
Entrance motor (M1)
Transport path switching solenoid
(SOL9)
Interface PC board (I/F)
Saddle stitcher controller board
Finisher controller board
[EAB1] Short paper jam in Saddle Stitch Finisher
Classification
Finisher jam
(Saddle stitcher section)
MJ-1108
Check item
Finisher, saddle stitcher
Feeding sensor
Junction box paper detection sensor
Transport path-2 sensor
Transport path-3 sensor
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
•
Motor check(M1)
•
Connector check(CN26)
•
Harness check
•
Board check
•
Connector check(CN1, CN2, CN5, CN7, CN8)
•
Harness check
•
Board check
•
Connector check(CN10, CN13, CN20)
•
Harness check
Short paper jam in Saddle Stitch Finisher
•
Check if there is any paper in the finisher, saddle stitcher
or the on the transport path of the equipment. Remove it if
there is.
•
Use paper accepted in the specifications.
•
Sensor check (S22)
•
Connector check
•
Harness check
•
Sensor check (S26)
•
Connector check (CN8)
•
Harness check
•
Sensor check (S27)
•
Connector check (CN20)
•
Harness check
•
Sensor check (S28)
•
Connector check (CN20)
•
Harness check
8 - 103
Measures
Remarks
Error item
Measures
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8