(5)
Remove the 3 E-rings [1], 2 bushings [2], 2
bearings [3] and 1 gear [4].
Notes:
•
When installing, check that the bearing
flange is outside the plate.
•
The pressure roller for the 25/30/35ppm
models and for the 45/50ppm models is
different. The edge of the shaft of the
pressure roller for 45ppm/50ppm is colored
blue for identification.
•
After a new pressure roller is installed in the
frame of the fuser unit, be sure to remove the
protection sheet attached to the roller to
avoid damaging or staining its surface.
e-STUDIO2555C/3055C/3555C/4555C/5055C
DISASSEMBLY AND REPLACEMENT
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
4 - 166
Fig. 4-463
Fig. 4-464
Fig. 4-465