Toshiba e-STUDIO 2555C Service Manual page 156

Notes:
1. When attaching the wire holder jig [1],
make sure that the wire has not shifted or
become loose.
2. The wire should come out of the slot of
the wire holder jig [1] and be passed
under the jig arm [2].
3. When installing the wire holder jig, be
careful of the orientation.
(4) Remove the tension springs [1] in the front
and rear sides.
(5) Remove the carriage wire [2].
(6) Rotate carriage-2 [1] in the direction shown
in the figure, while trying not to touch the
mirror. Then remove carriage-2 [1].
Notes:
Replace mirror-2 and -3 together with
carriage-2 [1]. Do not remove mirror-2 and -
3.
e-STUDIO2555C/3055C/3555C/4555C/5055C
DISASSEMBLY AND REPLACEMENT
[1]
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
4 - 20
[2]
[1]
Fig. 4-53
Fig. 4-54
Fig. 4-55