Toshiba e-STUDIO 2555C Service Manual page 665

[ED11] Sideways adjustment motor (M2) home position detection error
MJ-1107/1108 (when MJ-6104 is installed)
Classification
Other paper jam
Check item
Sideways adjustment motor
(M2)
Sideways deviation HP sensor
(S3)
Sideways adjustment motor
(M2)
Hole punch control PC board
Parts to be replaced
Sideways adjustment motor
Sideways deviation HP sensor
Hole punch control PC board
[ED12] Shutter home position error
Classification
Other paper jam
MJ-1107
Check item
Movable tray paper-full sensor
Shutter
Shutter opening/closing sensor Check if there is a disconnection of the connector, incorrect
Shutter clutch
Parts to be replaced
Movable tray paper-full sensor
Shutter opening/closing sensor
Shutter clutch
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Error content
Sideways adjustment motor (M2) home position detection error
Measures
Rotate sideways adjustment motor and fix its mechanism if it does
not rotate smoothly.
Check if the connectors on the hole punch controller PC board (HP
board) are disconnected from the sideways deviation HP sensor
(S3) and the sideways adjustment motor, or the harnesses are open
circuited. Correct if any.
Remark
Error content
Shutter home position error
Measures
Fix any mechanical problem occurring when the actuator is moved.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the movable tray paper-full sensor (S16).
If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN13) on the finisher controller PC board is
disconnected from the movable tray paper-full sensor (S16) and the
harnesses are open circuited. Correct if so.
Open and close the shutter.
Fix any mechanical problem.
installation or breakage of the shutter opening/closing sensor (S4).
If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN13) on the finisher controller PC board is
disconnected from the shutter opening/closing sensor (S4) and the
harnesses are open circuited. Correct if so.
Check if the connector (CN5) on the finisher controller PC board is
disconnected from the shutter clutch (CLT1) and the harnesses are
open circuited. Correct if so.
Remark
8 - 109
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8