Toshiba e-STUDIO 2555C Service Manual page 294

(18) Remove the fuser belt [1] from the front side.
(19) Remove the bearing [2] and collar [3].
Notes:
• When installing the fuser belt, be careful
not to let the silicon oil on the fuser belt
lubricating sheet come in contact with the
surface of the fuser belt. After installing,
check that there is no silicon oil on the
fuser belt. If silicon oil is running over
more than 25 mm from the edge of the
fuser belt, wipe it off using alcohol. If 25
mm or less, wipe it off with a dry cloth.
• Take care so that no damage or stains
are detected on the fuser belt.
• After reassembling the fuser belt, check
that there is no scratch on the surface
and the edges of the belt, and check that
the grease has not adhered on the belt
surface.
• When installing the fuser belt, mount its
center, edge and side thermistors inside
of the belt by holding them with your
fingers, paying attention not to deform
them.
• When installing the fuser belt, pay
attention that it is not caught with the
harness.
e-STUDIO2555C/3055C/3555C/4555C/5055C
DISASSEMBLY AND REPLACEMENT
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
4 - 158
[1]
[2]
Fig. 4-442
Fig. 4-443
Fig. 4-444
[3]