Toshiba e-STUDIO 2555C Service Manual page 1131

Sub
05/08 Mode Element
element
05 Adjustmen Printer Image Amount of void at the
t mode trailing edge
05 Adjustmen Printer Aligning ADU
t mode adjustment
05 Adjustmen Printer Aligning ADU
t mode adjustment
05 Adjustmen Printer
t mode
05 Adjustmen Printer Feeding Paper aligning
t mode system/Pa amount correction
per value (speed at low
transport temperature)
05 Adjustmen Printer Feeding Paper aligning
t mode system/Pa amount correction
per value (speed at low
transport temperature)
Item Subitem Code
4831
Small-sized paper 4832
Small-sized paper 4832
4833
1st drawer 4835
1st drawer 4835
Sub- Default Acceptable
Details
code value value
Non-standard paper 100 0-200
by bypass feeding
0 Plain paper/Recycled 0 0-50
paper
1 Thick paper/Special 0 0-50
paper
Recovery from toner - -
empty/waste toner full
0 Long size 5 -30-30
1 Middle size 4 -30-30
72
RAM Contents
M Adjusts the amount of void at the trailing edge of non-
standard paper by bypass feeding. When the value is
too small, stain may appear on the back side of paper.
0.1mm/step.
M 0.8mm/step
M 0.8mm/step
M Perform this code to recover from toner empty/waste
toner full.
M Sets the correction value for speed at low temperature
which is applied to the current adjustment value.
When the value increases by "1", the aligning amount
increases by approx. 0.54 mm.
* This code is valid for 45/50ppm only.
<Paper length>
Long size: 330 mm or longer
Middle size: 220 mm to 329 mm
Short size 1: 205 mm to 219 mm
Short size 2: 160 mm to 204 mm
Short size 3: 159 mm or shorter
M Sets the correction value for speed at low temperature
which is applied to the current adjustment value.
When the value increases by "1", the aligning amount
increases by approx. 0.54 mm.
* This code is valid for 45/50ppm only.
<Paper length>
Long size: 330 mm or longer
Middle size: 220 mm to 329 mm
Short size 1: 205 mm to 219 mm
Short size 2: 160 mm to 204 mm
Short size 3: 159 mm or shorter
Proce Servic
dure e UI
1 Yes
4
4
6
4
4