Toshiba e-STUDIO 2555C Service Manual page 730

Parts to be replaced
Transport motor
Finisher control PC board
[CC41] Paper holder cam home position abnormality
Classification
Finisher related service call
MJ-1107
Check Item
Paper holder cam
Paper holder home position sensor
(S6)
Replacement part
Paper holder home position sensor
(S6)
Finisher controller PC board
MJ-1108
Check item
Paper pusher cam
Paper holder home position
sensor
Parts to be replaced
Paper holder home position
sensor
Finisher control PC board
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Remark
Paper holder cam home position abnormality: The paper holder
cam is not at the home position.
If there is mechanical problem when the paper holder cam is
rotated, fix the mechanism.
Check the connectors and harnesses between the paper holder
home position sensor (S6) and the finisher control PC board
(CN17).
Measures
Rotate the paper pusher cam.
Fix any mechanical problem.
Check if the connector (CN9) on the finisher controller PC board is
disconnected from the paper holder home position sensor (S6) and
the harnesses are open circuited. Correct if so.
Remark
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 174
Contents
Measure
Measure