Toshiba e-STUDIO 2555C Service Manual page 994

Notes:
• The display of items on this screen varies depending on the types of data written on the USB device.
Each item is displayed only when each data file is written on the USB device in the following
conditions.
Item
1. SYSTEM FIRMWARE (OS Data)
2. ENGINE FIRMWARE
3. SCANNER FIRMWARE
4. SYSTEM SOFTWARE (HD Data)
5. RADF FIRMWARE
6. PFC FIRMWARE
7. FINISHER FIRMWARE
8. SADDLE FIRMWARE
9. PUNCH FIRMWARE
• If the USB device is not recognized properly, "USB device Not detected" message is displayed. In
this case, disconnect the USB device and connect again within 3 minutes, or shut down the
equipment and connect the device properly. Then repeat the procedure from (4).
• If any of the error messages below is displayed, confirm if the data file in the USB device is correct.
Then repeat the procedure from (4).
Error
number
01 Error Loadmodule
Machine Model Get Error
02
03 Copy Data with valid signature in USB
Storage
04 Other models ROMDATA TXXXXXXXX
* The version name comes at
"xxxx.xxx.x".
05 Copy Signature File in USB Storage
06 Patch and Normal package in one folder
of USB Storage
(6) Select the item with the digital keys.
"*" is displayed next to the selected item. Display or delete the "*" by pressing the number of the
item.
e-STUDIO2555C/3055C/3555C/4555C/5055C
FIRMWARE UPDATING
T212SF0Wxxxx.tar is written.
(xxxx is version.)
T210MWW.xxx is written. (xxx is version.)
T212SLGWW.xxx is written. (xxx is version.)
T212HD0Wxxxx.tar is written.
(xxxx is version.)
H576DFWW.0xxx is written.
(When MR-3025 is connected)
* xxx is version.
T210FWW.xxx is written.
(When GH-1080 is connected)
* xxx is version.
FIN1036T.xxx is written. (When MJ-1036 is connected.)
FIN1107T.xxx is written. (When MJ-1107 is connected.)
FIN1108T.xxx is written. (When MJ-1108 is connected.)
xxx is version.
SDL1108T.xxx is written.
(When MJ-1108 is connected.)
* xxx is version.
PUN6104T.xxx is written.
(When MJ-6104 is connected.)
* xxx is version.
Error message
11 - 10
Condition
Cause
Module loading failed.
Model information was not
downloaded.
Checking of data file failed.
Master data of other model are
stored.
Data files are not stored in the USB
device.
When both the system and patch
update packages are in the USB
device
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved