Toshiba e-STUDIO 2555C Service Manual page 254

Notes:
When the gear has been replaced, grease its teeth surface and the shaft.
[1] Apply a thin coat of the grease to the tooth surface of each gear.
[2] Apply a thin coat of the grease to whole outer circumference of each shaft.
[3] Apply a thin coat of the grease to whole outer circumference of each shaft.
[4] Apply a coat of the grease to the whole outer circumference of each shaft.
[5] Apply a coat of the grease to the whole inner circumference of each bearing.
[6] Apply 1 rice-sized grain of the grease to the whole outer circumference of each gear boss.
[7] Apply 1 rice-sized grain of the grease to the front side [a] and the rear side [b] of the cam.
[8] Apply a coat of the grease to the whole inner circumference of the bushing.
[1]
e-STUDIO2555C/3055C/3555C/4555C/5055C
DISASSEMBLY AND REPLACEMENT
[2]
[8] [7]
[a]
Fig. 4-332
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
4 - 118
[3]
[3] [4]
[5]
[6]
[b]