Toshiba e-STUDIO 2555C Service Manual page 674

Replace parts
Folding blade home position sensor
(S35)
Folding blade clutch (CLT3)
Saddle controller board
[EF18] Saddle Stitch Finisher additional folding roller home position detection abnormality
MJ-1108
Classification
Finisher jam (Saddle section)
Check item
Additional folding carrier
Additional folding home position
sensor (S39)
Additional folding motor (M20)
Saddle controller board
Replace parts
Additional folding home position
sensor (S39)
Additional folding motor (M20)
Saddle controller board
[EF19] Saddle paper folding jam
MJ-1108
Classification
Finisher jam (Saddle section)
Check item
Finisher
Exit transport sensor (S41)
Saddle controller board
Replace parts
Exit transport sensor (S41)
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
The additional folding roller home position cannot be
detected.
• Is there any mechanical problem when the additional
folding carrier is moved?
• Sensor check
• Connector check
• Harness check
• Motor check
• Connector check
• Harness check
• Connector check (CN18, CN19)
• Board check
Fold processed paper cannot be transported to the additional
folding roller.
• Is there any paper remaining in the paper transport path in
the equipment or the saddle stitch section of the Finisher?
• Sensor check
• Connector check
• Harness check
• Connector check (CN19)
• Board check
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 118
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks