Toshiba e-STUDIO 2555C Service Manual page 648

Check item
Entrance sensor
Paper position sensor
Finisher controller PC board
Parts to be replaced
Transport sensor
Entrance sensor
Paper position sensor
Finisher controller PC board
MJ-1108
Phenomenon of paper jamming
All
Parts to be replaced
Entrance sensor
Feeding sensor
Paper position sensor
Transport sensor
Finisher control PC board
[EA32] Finishing tray paper detection error
Classification
Paper jam in finisher section
MJ-1036
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Measures
• Sensor check (S1)
• Connector check (CN7, CN22)
• Harness check
• Sensor check (S6-1, S6-2)
• Connector check (CN1, CN2)
• Harness check
• Borad check
• Connector check (CN22)
• Harness check
Remark
Check item Measures
Finisher Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if
there is.
Entrance • Sensor check
sensor (S1) • Connector check
• Harness check
Feeding • Sensor check (S22)
sensor (S22) • Connector check (CN8)
• Harness check
Paper • Sensor check (S6-1, S6-2)
position • Connector check (CN1, CN2)
sensor • Harness check
Transport • Sensor check
sensor (S2) • Connector check
• Harness check
Finisher • Board check
control PC • Connector check (CN6)
board (FIN) • Harness check
Remark
Exit paper remaining jam
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 92
Error content