Check item
Other
Power
SYS board
LGC board
HDD
Replace parts
SYS board
LGC board
HDD
[E0A0]Image transport ready time-out jam
Classification
Other paper jam
Check item
LGC board
Parts to be replaced
LGC board
[E550] Paper remaining jam on the transport path
Classification
Other paper jam
Step
Check Item
Jamming transport path
1
Feed or transport roller possibly
2
causing multiple feeding
Sensor in the jamming area
3
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
•
Check if there is any paper in the equipment. Remove it if
there is.
•
If the error still occurs, check the following.
Check if the error is cleared by turning the power OFF and
then back ON.
•
Connector check
•
Board check
•
Connector check
•
Board check
•
Connector check
•
HDD check
Image transport ready time-out jam
Connector check
Paper remaining on the transport path when printing is finished
(caused by a multiple paper feeding)
Result
Open the cover of the unit/area whose
picture is flashing on the control panel
and remove any paper on the transport
path.
Check the feed roller.
•
Sensor check (Refer to the table
below)
•
Harness check
•
Connector check
8 - 65
Measures
Remarks
Error content
Measures
Remark
Error content
Measure
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8
Next
Step