Toshiba e-STUDIO 2555C Service Manual page 609

Parts to be replaced
Separation roller
Pickup roller
Transport roller
[E220] 2nd drawer transport jam (not reaching the feed sensor)
[E310] PFP upper drawer transport jam (not reaching the feed sensor)
[E340] PFP lower drawer transport jam (not reaching the feed sensor)
[E3D0] LCF transport jam (not reaching the feed sensor)
Classification
Paper transport jam
Check item
Feed sensor
Transport clutches (high
speed)
Transport clutches (low speed) •
DRV board
LGC board
Parts to be replaced
1st drawer feed sensor
Transport clutches (high
speed)
Transport clutches (low speed)
DRV board
LGC board
Feed roller
Separation roller
Pickup roller
Transport roller
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Replace it if it is worn out.
Replace it if it is worn out.
Replace it if it is worn out.
2nd drawer transport jam (not reaching the feed sensor)
PFP upper drawer transport jam (not reaching the feed sensor)
PFP lower drawer transport jam (not reaching the feed sensor)
LCF transport jam (not reaching the feed sensor)
• Sensor check (Perform the input check: 03-[ALL]OFF/[9]/[B])
• Connector check (CN462, J1114, J1078)
• Harness check
• Clutch check (Perform the output check: 03-230)
• Connector check (CN453, J1089)
• Harness check
Clutch check (Perform the output check: 03-233)
• Connector check (CN453, J1090)
• Harness check
• Board check
• Connector check (CN453, CN450, CN451)
• Harness check
• Board check
• Connector check (CN361, CN362)
• Harness check
Replace it if it is worn out.
Replace it if it is worn out.
Replace it if it is worn out.
Replace it if it is worn out.
8 - 53
Remark
Error content
Measures
Remark
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8