Toshiba e-STUDIO 2555C Service Manual page 668

Parts to be replaced
Finisher controller PC board
MJ-1108
Check item
Rear alignment plate
Rear alignment plate home
position sensor
Rear alignment motor
Parts to be replaced
Rear alignment plate home
position sensor
Rear alignment motor
Finisher controller PC board
[ED15] Paddle home position error
Classification
Other paper jam
MJ-1107
Check item
Paddle
Paddle home position sensor
Paddle motor
Finisher controller PC
board
Parts to be replaced
Paddle motor
Paddle home position sensor
Finisher controller PC board
MJ-1108
Check item
Paddle
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Remark
Measures
Move the rear alignment plate.
Fix any mechanical problem.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the rear alignment plate home position
sensor (S8). If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN18) on the finisher controller PC board is
disconnected from the rear alignment plate home position sensor
(S8) and the harnesses are open circuited. Correct if so.
Check if the connector (CN17) on the finisher controller PC board is
disconnected from the rear alignment motor (M6) and the
harnesses are open circuited. Correct if so.
Remark
Error content
Paddle home position error
Measures
Rotate the paddle. If there is any mechanical problem, fix its
mechanism.
Check if the connectors on the finisher controller PC board are
disconnected from the paddle home position sensor (S3) and the
paddle motor (M8), or the harnesses are open circuited. Correct if
any.
Remark
Measures
Rotate the paddle. If there is any mechanical problem, fix its
mechanism.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 112