Toshiba e-STUDIO 2555C Service Manual page 930

[B] Initialize LGC board
(1) Open the front cover, and check the destination printed on the white tape stuck on the
equipment.
(2) Start up with the Setting Mode (08).
(3) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(4) Perform "Destination display at SRAM initialization" (08-9060).
(5) Check whether the displayed destination (see the below figure) of the SRAM board (for the SYS
board) is the same as the one in step (1).
Remarks:
If the destinations are different, initialize the SRAM board (for the SYS board) with reference to
the following procedure.
 P. 9-26 "9.2.5 Precautions and procedure when replacing the SRAM board (for the SYS
board)"
(6) Perform "Printer all clear" (08-9090).
e-STUDIO2555C/3055C/3555C/4555C/5055C
REPLACEMENT OF PC BOARDS/HDD
Fig. 9-39
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
9 - 34