Parts to be replaced
Original intermediate transport
sensor
[E726] Transport/exit signal reception jam
Classification
RADF jam
Check item
RADF board
SYS board
Switching power supply
Parts to be replaced
RADF board
SYS board
Switching power supply
[E731] Stop jam at the original exit/reverse sensor
Classification
RADF jam
Check item
Exit roller
Stop jam at the original exit/
reverse sensor
RADF board
Parts to be replaced
Exit sensor
RADF board
Exit roller
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Transport/exit signal reception jam
•
Board check
•
Connector check
•
Harness check
•
Board check
•
Connector check
•
Harness check
•
Check if the 24V and 5V outputs of the switching power supply
are normal.
•
Board check
•
Connector check
•
Harness check
Stop jam at the original exit/reverse sensor
Clean the exit roller if it is stained.
•
Sensor check (Perform the input check: 03-[FAX] ON[7]/[E])
•
Connector check (J93, CN75)
•
Harness check
•
Board check
•
Connector check (CN75)
•
Harness check
Replace it if it is worn out.
8 - 75
Remark
Error content
Measures
Remark
Error content
Measures
Remark
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8