Toshiba e-STUDIO 2555C Service Manual page 568

Error code Classification
EA90 Finisher jam
(Saddle stitcher
section)
EAA0
EAB0
EAB1
EAD0 Other paper jam
EAE0
EAF1 Finisher jam
EB30 Other paper jam
EB50 Paper transport jam
EB60
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Contents
Door open jam: The delivery cover or inlet
cover has opened during printing. [MJ-1108]
Paper remaining in Saddle Stitch Finisher:
Paper remaining in Saddle Stitch Finisher [MJ-
1108]
Paper transport jam in Saddle Stitch Finisher:
Paper transport jam in Saddle Stitch Finisher
[MJ-1108]
Short paper jam: Short paper jam (Saddle
Stitch Finisher) [MJ-1108]
Print end command time-out jam: The printing
has not finished normally because of an error
occurring on the interface between the SYS
board and the engine firmware at the end of
printing.
Receiving time time-out jam: The printing has
been interrupted because of the
communication error between the equipment
and finisher when the paper is transported from
the equipment to the finisher.
Stack exit roller nip home position detection
error [MJ-1036]
Ready time time-out jam: The equipment
judges that the paper transport to the finisher is
disabled because of the communication error
between the equipment and finisher at the start
of printing.
Paper remaining on the transport path: The
multiple feeding of preceding paper caused the
misfeeding of upcoming paper.
Paper remaining on the transport path: The
multiple feeding of preceding paper caused the
misfeeding of upcoming paper (redetection
after no jam is detected at [EB50]).
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 12
Troubleshooting
P. 8-101
P. 8-101
P. 8-102
P. 8-103
P. 8-107
P. 8-107
P. 8-100
P. 8-107
P. 8-57
P. 8-59