Toshiba e-STUDIO 2555C Service Manual page 613

Parts to be replaced
Reverse sensor
Fuser motor
Reverse motor
Reverse gate solenoid
LGC board
Reverse roller
[E580] Stop jam at the reverse section
Classification
Paper transport jam
Check item
Reverse sensor
Reverse motor
Reverse gate solenoid
LGC board
Reverse roller
Upper exit roller
Parts to be replaced
Reverse sensor
Reverse motor
Reverse gate solenoid
LGC board
Reverse roller
Upper exit roller
[EB50] Paper remaining on the transport path due to multiple feeding
Classification
Paper transport jam
When the paper is fed from any of the 1st drawer, bypass feed unit or ADU:
(When the paper is fed from the 1st drawer:)
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
Stop jam at the reverse section
• Sensor check (Perform the input check: 03-[ALL]OFF/[9]/[D])
• Connector check (J1064, J1104)
• Harness check
• Motor check (Perform the output check: 03-121/171)
• Connector check (J1001, J1118, CN351)
• Harness check
• Solenoid check (Perform the output check: 03-222, 03-223)
• Connector check (J1010, J1118, CN351)
• Harness check
• Connector check (CN353, CN390)
• Harness check
• Board check
Roller check (attrition, deformation, deterioration)
Roller check (attrition, deformation, deterioration)
Paper remaining on the transport path due to multiple feeding
8 - 57
Remark
Error content
Measures
Remark
Error content
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
8