Toshiba e-STUDIO 2555C Service Manual page 664

Check item
Finisher
Parts to be replaced
PFC board
LGC board
[ED10] Skew adjustment motor (M1) home position detection abnormality
MJ-1107/1108 (when MJ-6104 is installed)
Classification
Other paper jam
Check item
Skew adjustment motor (M1)
Skew HP sensor (S2)
Skew adjustment motor (M1)
Hole punch control PC board
Parts to be replaced
Skew adjustment motor
Skew HP sensor
Hole punch control PC board
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Check if the connector on the equipment is disconnected from the
finisher or the harnesses are open circuited. Correct if any.
Error content
Skew adjustment motor (M1) home position detection abnormality
Measures
Rotate skew adjustment motor and fix its mechanism if it does not
rotate smoothly.
Check if the connectors on the hole punch controller PC board (HP
board) are disconnected from the skew HP sensor (S2) and the
skew adjustment motor, or the harnesses are open circuited.
Correct if any.
Remark
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 108
Measures
Remark