Check Item
Transport path
Punch motor (M3)
Punch home position sensor (S4)
Replacement part
Punch home position sensor (S4)
Punch motor (M3)
Hole punch control PC board (HP)
[CC71] Punch ROM checksum error
MJ-1107/1108 (When MJ-6104 is installed)
Classification
Finisher related service call
Check Item
Hole punch control PC board (HP)
Replacement part
Hole punch control PC board (HP)
[CC72] Punch RAM read/write error
MJ-1107/1108 (When MJ-6104 is installed)
Classification
Finisher related service call
Check Item
Hole punch control PC board (HP)
Replacement part
Hole punch control PC board (HP)
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
If there is any paper remaining on the transport path, remove
the paper.
•
If there is mechanical problem when the punch motor (M3) is
rotated, fix the mechanism.
•
Check the connectors and harnesses between the hole
punch control PC board (HP) and punch motor (M3).
•
Sensor check
•
Harness check
Punch ROM checksum error: Abnormality of checksum value
on Hole punch controller PC board is detected when the power
is turned on.
Board check
Punch RAM read/write error: Abnormality of checksum value on
Hole punch controller PC board is detected when the power is
turned on.
Board check
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 178
Measure
Measure
Contents
Measure
Measure
Contents
Measure
Measure