Toshiba e-STUDIO 2555C Service Manual page 369

• Test print mode (04)
Refer to  P. 5-10 "5.5 Test print mode (test mode 04)".
• Adjustment mode (05)
Refer to  P. 5-11 "5.6 Operation Procedure in Adjustment Mode (05)",  P. 5-14 "5.7 Test print
pattern in Adjustment Mode (05)", and "15. SELF-DIAGNOSIS CODE (03/04/05/08 CODE)" -
"Adjustment Code (05)."
Notes:
When the power should be turned OFF, be sure to shut down the equipment by pressing the
[ON/OFF] button for a few seconds.
Remarks:
• In "RAM", the SRAM of the board in which the data of each code is stored is indicated. "M"
stands for the LGC board and "SYS" stands for the SYS board.
• Setting mode (08)
Refer to  P. 5-18 "5.8 Operation Procedure in Setting Mode (08)" and "15. SELF-DIAGNOSIS
CODE (03/04/05/08 CODE)" - "Setting Code (08)."
Notes:
When the power should be turned OFF, be sure to shut down the equipment by pressing the
[ON/OFF] button for a few seconds.
Remarks:
• In "RAM", the SRAM of the board in which the data of each code is stored is indicated. "M"
stands for the LGC board, "SYS", "NIC" or "UTY" stands for the SYS board.
• Assist mode (3C)
Refer to  P. 5-20 "5.9 Assist Mode (3C)".
• HDD assist mode (4C)
Refer to  P. 5-23 "5.10 HDD Assist Mode (4C)".
• File system recovery mode (5C)
Refer to  P. 5-27 "5.11 File System Recovery Mode (5C)".
• SRAM clear mode (6C)
Refer to  P. 5-32 "5.12 SRAM Clear Mode (6C)".
• List print mode (9S)
Refer to  P. 5-34 "5.13 List print mode (9S)".
• PM support mode (6S)
Operation procedure
[6][START]
[POWER]
• Firmware update mode (49/89)
Refer to  P. 11-1 "11. FIRMWARE UPDATING".
• Password reset mode (489)
This mode resets the administrator password and service password. The user data is erased when
resetting the passwords.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
(Operation started)
5 - 3
[POWER] OFF/ON
(Exit)
e-STUDIO2555C/3055C/3555C/4555C/5055C
SELF-DIAGNOSTIC MODE
5