Toshiba e-STUDIO 2555C Service Manual page 728

[CC02] Stack exit roller nip home position detection error
MJ-1036
Replacement part
Stack exit roller shift motor (M6)
Stack exit roller home position
sensor (S13)
[CC20] Saddle communication error
MJ-1108
Classification
Finisher related service call
Check Item
Interface PC board (I/F)
Finisher control PC board (FIN)
Saddle control PC board (SDL)
Interface PC board (I/F)
Finisher control PC board (FIN)
Saddle control PC board (SDL)
Finisher control PC board (FIN)
Saddle control PC board (SDL)
Replacement part
Interface PC board (I/F)
Finisher control PC board (FIN)
Saddle control PC board (SDL)
[CC30] Stack transport motor abnormality
* You receive a [CC30] error when the [EA70] error occurs three times in succession.
Classification
Finisher related service call
MJ-1107
Check Item
Stack transport belt
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
The stack exit roller home position sensor (S13) does not detect
that the exit roller is not at the upper position after the stack exit
roller motor (M6) has been driven in the specified time when the
exit roller is moved down.
The stack exit roller home position sensor (S13) does not detect
that the exit roller is at the upper position after the stack exit
roller shift motor (M6) has been driven in the specified time
when the exit roller is moved up.
Saddle communication error
• Connector check
• Harness check
• Connector check
• Harness check
• Connector check
• Harness check
Board check
Board check
Board check
Update the firmware version of the finisher control PC board
(FIN).
Update the firmware version of the saddle control PC board
(SDL).
Stack transport motor abnormality: The stack transport motor is
not rotating or the stack transport belt is not moving normally.
If there is mechanical problem when the stack transport belt is
moved, fix the mechanism.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 172
Measure
Contents
Measure
Measure
Contents
Measure