Configuring Hop Count - Avaya 2330 Manual

2. To access the bridge command context, enter:
3. To configure the priority value, enter:
Table 58: Variable definitions
<value>
Restoring the default bridge priority value
Use the procedure in this section to restore the bridge priority value to the default setting.
Procedure steps
1. To access configuration mode, enter:
2. To access the bridge command context, enter:
3. To restore the bridge priority value to the default setting, enter:
Table 59: Variable definitions
<value>

Configuring hop count

Hop count in the packet gets decremented on every node that it traverses. Once the hop count
reaches zero, the packet becomes stale. Use the procedure in this section to configure the
maximum hops for a BPDU.
Configuration — Layer 2 Ethernet
configure terminal
bridge
priority <value>
Variable
configure terminal
bridge
no priority <value>
Variable
Configuring Common Spanning Tree
Value
Specifies the bridge priority. The default
value is 32768 (or hex 0x8000). Valid values
are 0 to 61440, and are increments of
4096.
Value
Specifies the bridge priority that is currently
configured. Valid values are 0 to 61440, and
are increments of 4096. The default value is
32768.
July 2013 141