Disabling An Access Port; Verifying An Access Port; Example Of Configuring An Access Port On A Wan Interface - Avaya 2330 Manual

Disabling an access port

Use the procedure in this section to disable an access port.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To disable the selected access port, enter:

Verifying an access port

Use the procedure in this section to verify the successful configuration of an access port.
Procedure steps
1. To view information related to the interface mode, enter:
2. To view information related to the operation of the access port, enter:

Example of configuring an access port on a WAN interface

Procedure steps
1. To access configuration mode, enter:
2. To select a bundle (in this example, the bundle identified as T1IF), enter:
3. To link the bundle to an interface (in this example, the interface is port 1 of the
4. To configure the encapsulation, enter:
Configuration — Layer 2 Ethernet
configure terminal
interface bundle <bundle-name>
no switchport
show bridge port
show interface bundle <bundle-name>
configure terminal
interface bundle T1IF
module in slot 4), enter:
link t1 4/1
Configuring an access port on a WAN interface
July 2013 103