Multiple Spanning Tree Protocol configuration
Resetting the revision number
Use the procedure in this section to restore the default revision number (0).
Procedure steps
1. To access configuration mode, enter:
2. To access the bridge command context, enter:
3. To access the MSTP command context, enter:
4. To configure the revision number, enter:
Table 57: Variable definitions
<revision-number>
Configuring Common Spanning Tree
Use the procedures in this section to configure CST elements.
Important:
If you enter the spanning-tree command under an interface, all IP information for that
interface is removed.
Configuring bridge priority
You can assign a priority to the bridge. The lower the priority, the greater the chance that the
bridge becomes root for the CST.
Procedure steps
1. To access configuration mode, enter:
140
Configuration — Layer 2 Ethernet
configure terminal
bridge
mstp
no revision <revision-number>
Variable
Comments? infodev@avaya.com
Value
Specifies the revision number that is
currently configured. The default value is 0.
Valid values are 0 to 255.
July 2013