Configuring LACP system priority
Use the procedure in this section to configure the system priority for a local system. The system
priority is used in determining the system responsible for resolving conflicts in the choice of
aggregation groups.
Lower numerical values have higher priorities.
Procedure steps
1. Enter configuration mode:
2. Enter the configuration context:
3. To configure the priority for the system, enter:
Table 46: Variable definitions
<priority value>
Restoring the default LACP system priority
Use the procedure in this section to reset the system priority of the local system to the default
value (32768).
Configuration — Layer 2 Ethernet
Variable
configure terminal
lacp
priority <priority value>
Variable
Configuring LACP system priority
Value
down. The supported values are the
following:
•
short
: a fast timeout. This is
approximately 3 seconds.
long
•
: a slow timeout. This is
approximately 90 seconds.
long
The default value is
Value
The LACP priority that you assign to the
system. The default value is 32768. Valid
values are 1 to 65535.
.
July 2013
109