Verifying Vlan Stacking Configuration; Example Of Configuring Vlan Stacking - Avaya 2330 Manual

VLAN stacking configuration
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To disable VLAN stacking, enter:

Verifying VLAN stacking configuration

Use the procedure in this section to verify the successful operation of your VLAN stacking
configuration.
Procedure steps
To verify the successful operation of VLAN stacking configuration, enter:
show bridge port

Example of configuring VLAN stacking

In this example, the enterprise switch (that is, the Avaya Secure Router 2330/4134 acting as
an Enterprise switch) hosts computers on the LAN segments, and provides connectivity
through the WAN interface to the Carrier Device (that is, the Secure Router 2330/4134 acting
as a Carrier Device).
For each incoming customer packet that is tagged with the Customer VLAN, a Carrier VLAN
tag is added by the Carrier Device.
MSTP is enabled on all interfaces.
Traffic from hosts on Port A are tagged with VLAN 100 by the Enterprise Switch.
The switches are connected as follows:
• Enterprise switch: Port A is Ethernet 5/1
• Enterprise switch: Port B is a T1, port 4/1
• Carrier device: Port C is a T1, port 4/1
Customer traffic received by the Carrier Device is tagged with VLAN 1000.
The following figure shows the example network setup.
128 Configuration — Layer 2 Ethernet
configure terminal
interface [range] ethernet <slot/port>
switchport mode [access|trunk|hybrid]
Comments? infodev@avaya.com
July 2013