Deleting a remote Maintenance End Point
Use the procedure in this section if you must delete a remote MEP.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To specify a previously created MD, enter:
5. To specify a previously created MA, enter:
6. To delete an MEP, enter:
Configuring a Maintenance Intermediate Point
Use the procedure in this section to define an MIP.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To create an MD, or to specify a previously created MD, enter:
5. To create an MIP, enter:
Configuration — Layer 2 Ethernet
configure terminal
oam
cfm
md <WORD>
ma <WORD>
no rmep <rmep id>
configure terminal
oam
cfm
md <WORD>
Deleting a remote Maintenance End Point
July 2013
59