Example Of Configuring Gvrp; Example Of Configuring Switch_1 - Avaya 2330 Manual

GVRP configuration

Example of configuring GVRP

In this example, the switch ACCESS_1 is connected to SWITCH_1 through an 802.1Q trunk.
SWITCH_1 is also connected to SWITCH_2 using an 802.1Q trunk. GVRP is enabled on both
the SWITCH_1 and SWITCH_2, and on each GVRP port on those switches. Dynamic VLAN
creation is enabled on the switches, and the port from SWITCH_1 to ACCESS_1 is set to
GVRP fixed mode because the ACCESS_1 device does not send join messages and the
SWITCH_1 device would prune all VLANs if it were in the normal default mode.
Figure 23: GVRP configuration network scenario

Example of configuring SWITCH_1

Procedure steps
1. To access configuration mode, enter:
2. To select Ethernet interface 5/1, enter:
3. To configure the interface as a trunk port, enter:
4. To access the GVRP command context, enter:
174 Configuration — Layer 2 Ethernet
configure terminal
interface ethernet 5/1
switchportswitchport mode trunk
Comments? infodev@avaya.com
July 2013