Chapter 4: HTTPS configuration
Use the procedures in this section to configure and manage access to EDM over a Web browser.
Configuring HTTP mode
If you do not require secure connection to the switch over the Web, use the following procedure
to disable the Web server secure-only option. Both HTTP and HTTPS connections are
available. You can use CLI or ACLI to disable the secure-only option.
Procedure steps
1. Open a telnet connection to the switch.
2. If you are using CLI, at the prompt, enter the following command:
3. If you are using ACLI, access the Global Configuration mode. At the prompt, enter
Configuring HTTPS mode
If you disable HTTPS mode and require secure connection to the switch over the Web, use
the following procedure to re-enable the Web server secure-only option. Only HTTPS
connections will be available. You can use CLI or ACLI to enable the secure-only option.
Procedure steps
1. Open a telnet connection to the switch.
2. If you are using CLI, at the prompt enter the following command:
User Interface Fundamentals
procedures
config web-server secure-only disable
the following command:
no web-server secure-only
July 2013
25