Configuring Passive Mode; Configuring Active Mode - Avaya 2330 Manual

Link aggregation configuration
Table 42: Variable definitions
<value>

Configuring passive mode

In passive mode, the Secure Router 2330/4134 does not initiate the channel, but does
understand incoming LACP packets. The peer (in active state) initiates negotiation to form the
aggregation channel with the peer.
Procedure steps
1. Enter configuration mode:
2. To select an interface, enter:
3. Enter the configuration context:
4. To add the selected physical port to a link (channel group), enter
Table 43: Variable definitions
<value>

Configuring active mode

In the active state, the Secure Router 2330/4134 initiates the negotiation. The link aggregate
forms if the other end is running in LACP active or passive mode.
Procedure steps
1. Enter configuration mode:
2. To select an interface, enter:
106 Configuration — Layer 2 Ethernet
Variable
configure terminal
interface ethernet <slot/port>
lacp
channel-group <value> mode passive
Variable
configure terminal
Comments? infodev@avaya.com
Value
The channel group ID number. Valid values
are 1 to 8.
Value
The channel group ID number. Valid values
are 1 to 8.
July 2013