Disabling Gvrp On An Interface; Configuring Gvrp For Dynamic Vlan Creation - Avaya 2330 Manual

Table 92: Variable definitions
{normal | fixed | forbidden}

Disabling GVRP on an interface

Use the commands in this section to disable GVRP on an interface.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To access the GVRP command context, enter:
4. To disable GVRP on the selected interface, enter:

Configuring GVRP for dynamic VLAN creation

GVRP can dynamically create VLANs on devices for trunking purposes. When you enable
GVRP dynamic VLAN creation, a Secure Router 2330/4134 adds VLANs to its database when
it receives GVRP join messages about VLANs it does not have.
Configuration — Layer 2 Ethernet
Variable
configure terminal
interface [range] ethernet <slot/port>
gvrp
no gvrp-enable
Disabling GVRP on an interface
Value
Specify the port registration state.
By default, GVRP ports are in the "normal"
registration mode. The ports use GVRP join
messages from neighboring switches to
prune the VLANs running across the 802.1Q
trunk link.
If the device on the other side is incapable of
sending GVRP messages, or if you do not
want to allow the switch to prune any of the
VLANs, use the "fixed" mode. Fixed mode
ports will forward for all VLANs that exist in
the switch database.
Ports in forbidden mode forward only for
VLAN 1.
July 2013 169