Interface mode configuration
Verifying trunks
Use the procedure in this section to verify the successful configuration of trunks. With Release
10.2 and later, the show interface ethernet command displays the highest supported
capability for each interface: FE for Fast Ethernet and GE for Gigabit Ethernet.
Procedure steps
1. To view information related to the interface mode, enter:
2. To view information related to the operation of the trunk port, enter:
Example of configuring trunking on a chassis Ethernet interface
Procedure steps
1. To access configuration mode, enter:
2. To select the chassis Ethernet interface (in this example, interface 0/1), enter:
3. To configure the interface as a Layer 2 interface, enter:
4. To configure the interface as a trunk, enter:
Configuring trunking on a WAN interface
Use the procedures in this section to configure trunking on a WAN interface. For detailed
information about how to configure WAN interfaces, see Avaya Secure Router 2330/4134
Configuration — WAN interfaces (NN47263-500).
For an example network scenario that shows the use of trunking, see
VLAN stacking
88
Configuration — Layer 2 Ethernet
show bridge port
show interface ethernet <slot/port>
configure terminal
interface ethernet 0/1
switchport
switchport mode trunk
on page 128.
Comments? infodev@avaya.com
Example of configuring
July 2013