Creating A Maintenance Domain - Avaya 2330 Manual

Ethernet Connectivity Fault Management configuration

Creating a Maintenance Domain

Use the procedure in this section to create an MD within which you can manage Ethernet traffic.
Ensure you specify the level for each MD. The levels separate MDs from each other and
provide different areas of functionality.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To create the MD, enter:
5. To specify the full name for the MD, enter:
6. To specify the level for the MD, enter:
Table 14: Variable definitions
level <value>
md <WORD>
name <WORD>
54 Configuration — Layer 2 Ethernet
configure terminal
oam
cfm
md <WORD>
name <WORD>
level <value>
Variable
Comments? infodev@avaya.com
Value
The MD level. The default value for this
parameter is 7. To configure the level, enter
a value in the range 0 to 7. The levels define
the MD as follows:
• 0–2 (operator levels)
• 3–4 (provider levels)
• 5–7 (customer levels)
The short name for the MD (up to eight
characters). For example,
The full name of the MD (up to 31
characters). Place quotation marks around
the full name. For example,
full name"
. The full name is used in
MD1 .
name "MD 1-
July 2013