5. To delete an MIP, enter:
Configuring Continuity Check Messages
Use the procedure in this section to define continuity check parameters for an MA.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To create an MD, or to specify a previously created MD, enter:
5. To create an MA, or to specify a previously created MA, enter:
6. To configure parameters for CCM, enter:
Table 19: Variable definitions
ma <WORD>
md <WORD>
cc-interval <value>
Configuration — Layer 2 Ethernet
md <WORD>
no mip <mip id>
configure terminal
oam
cfm
md <WORD>
ma <WORD>
cc [cc-interval <value>] [cc-priority <value>] [auto-detect-
rmeps {enable|disable}]
Variable
Configuring Continuity Check Messages
Value
The short name for the MA (up to eight
characters). For example,
The short name of the MD (up to eight
characters). For example
The CCM transmission interval in ms. Enter
one of the following values:
• 1000
• 10000
• 60000
• 600000
MA1
.
MD1
.
July 2013
61