Changing The Channel Group; Example Of Changing The Channel Group Number To Reconfigure An Interface - Avaya 2330 Manual

3. Enter the configuration context:
4. To add the selected physical port to a link (channel group), enter
Table 44: Variable definitions
<value>

Changing the channel group

To quickly reconfigure the channel group or LACP mode of an interface, it is not necessary to
first remove previous configuration. You can simply alter the channel group number.
Example of changing the channel group number to reconfigure an
interface
Procedure steps
1. Enter configuration mode:
2. To select an interface, enter:
3. Enter the configuration context:
4. To assign the channel group number (in this example, channel group 1) and specify
5. To reconfigure the interface to passive mode, change the channel-group number
Configuration — Layer 2 Ethernet
interface ethernet <slot/port>
lacp
channel-group <value> mode active
Variable
configure terminal
interface ethernet <slot/port>
lacp
the LACP mode (in this example, active mode), enter:
channel-group 1 mode active
by entering:
channel-group 2 mode passive
Value
The channel group ID number. Valid values
are 1 to 8.
Changing the channel group
July 2013 107