Example Of Configuring Trunking On A Wan Interface; Configuring A Hybrid Link On An Ethernet Interface - Avaya 2330 Manual

Interface mode configuration

Example of configuring trunking on a WAN interface

Procedure steps
1. To access configuration mode, enter:
2. To select a bundle (in this example, the bundle identified as BRI1IF), enter:
3. To link the bundle to an interface (in this example, the interface is port 1 of the
4. To configure the encapsulation, enter:
5. To configure the interface as a Layer 2 interface, enter:
6. To configure the interface as a trunk interface, enter:

Configuring a hybrid link on an Ethernet interface

A hybrid link is a LAN segment that contains both VLAN-aware and VLAN-unaware devices.
Consequently, a hybrid link can carry both VLAN tagged frames and other (untagged or priority-
tagged) frames.
Use the procedure in this section to enable a hybrid link between devices.
Procedure steps
1. To access configuration mode, enter:
2. To select an Ethernet interface, enter:
3. To configure the interface as a Layer 2 interface, enter:
4. To configure the interface as a hybrid port, enter:
92 Configuration — Layer 2 Ethernet
show interface bundle <bundle-name>
configure terminal
interface bundle BRI1IF
module in slot 3), enter:
link t1 3/1
encapsulation ppp
switchport
switchport mode trunk
configure terminal
interface [range] ethernet <slot/port>
switchport
Comments? infodev@avaya.com
July 2013