Adding comments at the beginning of a configuration file
Use the procedure in this section to add comments at the beginning of the Ethernet area of a
configuration file.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To enter a comment:
Table 35: Variable definitions
<string>
<slot/port>
Adding comments at the end of a configuration file
Use the procedures in this section to add comments to an interface. The comments appear at
the end of the Ethernet area of a configuration file.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To enter a comment:
Configuration — Layer 2 Ethernet
configure terminal
interface ethernet <slot/port>
REM <string>
Variable
configure terminal
interface ethernet <slot/port>
REM_ <string>
Adding comments to an interface
Value
Specifies the comments. The string length
for comments is 80 characters. You must
enclose comments in quotation marks. For
example,
REM "Configured on July
30"
.
Specifies the slot and port numbers that
identify the port for configuration. For
example, 6/1.
July 2013
79