Disabling A Hybrid Link; Verifying A Hybrid Link; Example Of Configuring A Hybrid Link On A Chassis Ethernet Interface - Avaya 2330 Manual

3. To remove a specific VLAN from the selected hybrid link, enter:

Disabling a hybrid link

Use the procedure in this section to disable a hybrid link.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To disable the hybrid link on the interface, enter:

Verifying a hybrid link

Use the procedure in this section to verify the successful configuration of a hybrid link. With
Release 10.2 and later, the show interface ethernet command displays the highest
supported capability for each interface: FE for Fast Ethernet and GE for Gigabit Ethernet.
Procedure steps
1. To view information related to the interface mode, enter:
2. To view information related to the operation of the hybrid interface, enter:

Example of configuring a hybrid link on a chassis Ethernet interface

Procedure steps
1. To access configuration mode, enter:
2. To select an Ethernet interface (in this example, Ethernet interface 0/1), enter:
Configuration — Layer 2 Ethernet
interface [range] ethernet <slot/port>
switchport hybrid remove vlan <vid> egress {tagged|untagged}
configure terminal
interface [range] ethernet <slot/port>
no switchport
show bridge port
show interface ethernet <slot/port>
configure terminal
interface ethernet 0/1
Configuring a hybrid link on an Ethernet interface
July 2013 95