GVRP configuration
leaveall <value>
Resetting GVRP timers
To reset GVRP timers to default values, you must reconfigure the timers. The procedure in
this section shows how to reconfigure timers to the default values.
Procedure steps
1. To access configuration mode, enter:
2. To select an Ethernet interface, enter:
3. To access the GVRP command context, enter:
4. To reset GVRP timers to default values on the selected interface, enter:
Verifying GVRP configuration
Use the procedure in this section to display GVRP information, and verify successful
operation.
Procedure steps
1. To view detail information for GVRP, enter:
172
Configuration — Layer 2 Ethernet
Variable
configure terminal
interface [range] ethernet <slot/port>
gvrp
timer join 20 leave 60 leaveall 1000
Comments? infodev@avaya.com
Value
The leave timer default is 60.
The Leaveall timer starts when a GARP
application entity starts. When this timer
expires, the entity sends a LeaveAll
message so that other entities can re-
register attribute information, and then a
LeaveAll timer starts again.
The timer value is expressed in centi-
seconds. Valid values are in the range 1 to
10000.
The leaveall timer default is 1000.
July 2013