MAC entry configuration
Procedure steps
1. To access configuration mode, enter:
2. To add entries to the MAC address table, enter:
Verifying static MAC address entries
After you have configured static MAC Address entries, use the procedure in this section to
verify operation.
Procedure steps
To verify static MAC address configuration, enter:
show bridge mac static
Example of configuring static MAC address entries
In this example, VLANs 10 and 11 and interfaces 6/1 and 6/2 have been previously
configured.
Procedure steps
1. To create a static MAC address entry for interface 6/1, enter:
2. To create a static MAC address entry for interface 6/2, enter:
3. To remove the MAC entry for interface 6/1, enter:
Configuring MAC address aging time
Use the procedure in this section to specify an age-out time for a learned MAC address. The
learned MAC address will persist until the configured age-out time is expired.
136
Configuration — Layer 2 Ethernet
configure terminal
no mac address <mac addr> {forward|discard} <interface> vlan
<vid>
mac address 0000.5555.5550 forward ethernet6/1 vlan 10
mac address 0000.6666.3333 discard ethernet6/2 vlan 11
no mac address 0000.5555.5550 forward ethernet6/1 vlan 10
Comments? infodev@avaya.com
July 2013