Configuring Poe Port Priority Commands - Avaya 2330 Manual

Configuring PoE port priority commands

Use the procedure in this section to configure the priority of PoE ports. When available power
falls below the configured value, the lowest priority ports are shut down first.
Procedure steps
1. To access configuration mode, enter:
2. To configure PoE port priority, enter:
Table 6: Variable definitions
<port priority>
<slot/port>
Configuration — Layer 2 Ethernet
Variable
configure terminal
poe portpriority <slot/port> <port priority>
Variable
Configuring PoE port priority commands
Value
impact on the system configuration. For
ports that are in "auto" or "static" mode, the
port power is enabled and powered
devices connected to these ports receive
power.
no poe portpower <slot/port>
•
disables power on port <slot/port>. You
can configure this only when the mode of
operation is "auto" or "static" mode. If you
use this command when the mode of
operation is "never", the command has no
impact on the system configuration. For
ports that are in "auto" or "static" mode, the
port power is disabled and powered
devices connected to these ports do not
receive power.
The default value is power disabled on all 24
ports of a PoE card.
Value
Specifies the slot and port number that
identify the port to configure. Valid values for
slot are 5 to 7. Valid values for port are 1 to
24.
Valid values for <port priority> are in the
range of 1 to 3 (1=critical; 2=high; 3=low).
The default value for port priority is 3.
July 2013 47