Deleting A Maintenance Intermediate Point - Avaya 2330 Manual

Ethernet Connectivity Fault Management configuration
6. To specify the MIP interface, enter:
7. (Optional) To specify the state (enabled or disabled) for the MIP, enter:
8. To specify the VLAN with which the MIP is associated, enter:
Table 18: Variable definitions
<WORD>
<interface id>
<mip id>
<vid>

Deleting a Maintenance Intermediate Point

Use the procedure in this section if you must delete an MIP.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To specify the MD with which the MIP is associated, enter:
60 Configuration — Layer 2 Ethernet
mip <mip id>
An MIP is enabled by default when you create it.
interface <interface id>
state {enable|disable}
vlan <vid>
Variable
configure terminal
oam
cfm
Comments? infodev@avaya.com
Value
The short name of the MD (up to eight
characters). For example
The interface name. The interface ID can be
up to 16 characters. There is no default
value. For example, ethernet0/1
The numerical identifier for the MIP. There is
no default value. Enter a value in the range
from 1 to 8191. For example,
ethernet0/1 13
.
The VLAN ID with which to associate the
MIP. The default value is 0 (untagged). Enter
a VID in the range 0 to 4000.
MD1
.
.
mip
July 2013