Removing An Auto-Detected Remote Maintenance End Point; Issuing Cfm Loopback Tests - Avaya 2330 Manual

Ethernet Connectivity Fault Management configuration
cc-priority <value>
auto-detect-rmeps {enable|disable}
Removing an auto-detected remote Maintenance End
Point
Use the procedure in this section to remove auto-detected remote MEPs from an MA.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To create an MD, or to specify a previously created MD, enter:
5. To create an MA, or to specify a previously created MA, enter:
6. To remove auto detected remote MEPs from the MA, enter:

Issuing CFM loopback tests

Use the procedures in this section to issue CFM loopback messages and verify that remote
MEPs or MIPs are accessible.
62 Configuration — Layer 2 Ethernet
Variable
configure terminal
oam
cfm
md <WORD>
ma <WORD>
remove-ad-rmeps
Comments? infodev@avaya.com
Value
The default value is 10000 ms.
The CCM priority. This value is the 3-bit user
priority field in the VLAN tag. Enter a value in
the range 0 to 7. The default value is 7.
Turns the auto-detection of remote MEPs on
disable
or off. The default is .
July 2013