Interface mode configuration
For an example network scenario that shows the use of trunking, see
VLAN stacking
Enabling an access link on an Ethernet port
Use the procedure in this section to enable an access link between the devices.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To configure the interface as an access port, enter:
Associating VLANs with access links
There can be only one VLAN assigned to an access port. VLAN ID 1 is the default VLAN
assigned to each port. Use the procedures in this section to specify the VLANs to add to or
remove from an access link.
Changing the VLAN on an access port
Use the procedure in this section to change the VLAN assigned to an access link.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To assign a VLAN to the selected access port, enter:
Disabling an access port
Use the procedure in this section to disable an access port.
100
Configuration — Layer 2 Ethernet
on page 128.
configure terminal
interface [range] ethernet <slot/port>
switchport
configure terminal
interface [range] ethernet <slot/port>
switchport pvid <vid>
Comments? infodev@avaya.com
Example of configuring
July 2013