ma <WORD>
md <WORD>
<mep id>
<interface id>
mep-state {enable | disable}
Deleting a Maintenance End Point
Use the procedure in this section if you must delete an MEP.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To specify a previously created MD, enter:
5. To specify a previously created MA, enter:
6. To delete an MEP, enter:
Configuration — Layer 2 Ethernet
Variable
configure terminal
oam
cfm
md <WORD>
ma <WORD>
no mep <mep id> <interface id>
Configuring a Maintenance End Point
Value
The short name for the MA (up to eight
characters). For example,
The short name of the MD (up to eight
characters). For example
The numerical identifier for the MEP. There
is no default value. Enter a value in the range
from 1 to 8191. For example,
The interface name. The interface ID can be
up to 16 characters. There is no default
ethernet0/1
value. For example,
An MEP is disabled by default. Enter
enable
when you create the MEP to ensure
it is activated. If you must later deactivate the
MEP, use this command and enter
disable
.
MA1
.
MD1
.
mep 101
.
.
July 2013
57